Rule 1100 GPH / 4160 LPH Fully Automatic Bilge Pump

$149.95

This item is out of stock

Rule Pumps 27S, Automatic 1100 GPH fully submersible 12 volt DC bilge pump offers impressive pumping power for its size and cost. Competitive models in this pumping range are much larger and far more expensive. It features an easy clean snap lock strainer, silent and vibrationless operation, anti-airlock protection, compact, efficient long life motor, marine grade blocked wiring, ignition protection, no burn-out when run dry and rust and corrosion protection. minutes.Power use in the checking mode is minimal.

Specifications

Automatic Operation: Pump turns on and checks for water approximately every 2-1/2 minutes. If resistance (water) is found, it will run for as long as water is present. When all the water is pumped out, the pump shuts off and returns to its 2-1/2 minute test cycle. Amp Draw During Automatic Check: 0.5 Amps in a 24 hour period Manual Operation: The pump can be started at any time by disconnecting it from the power source, waiting for 5 seconds and reconnecting to the power source Fuse Size: 6 ampsAmp Draw @ 12 Volts: 3.3 Amp Draw @ 13.6 Volts: 5.0 Discharge Opening: 1-1/8" Discharge Finish : Barbed Housing Material: ABS Strainer Material: ABS Impeller Material: Nylon Shaft Material: Stainless Seal Material: Nitril/TeflonTemperature Limit: 200 F Fluid Capabilities: Bilge Water Typical Life: 1500 hours Wire Length: 29" Wire Gauge : 16 gaugeHeight: 4-1/4" Width: 2-3/8" Depth: 2-3/8" Weight: 10 oz Certifications: NMMA Type Accepted Equipment # 704216, IMCI Certified - ISO 8849, CE Certified, UPC Code 0-42237-08314-2